Fan Panel, 2U — 60 or 80 mm

A 2U fan panel for our 10-inch rack, for two 60 mm or two 80 mm fans.

Two fans, and only two. Four 60 mm bores need 228 mm of a 224 mm field, and three would centre one fan on the print seam. The arithmetic decides this, so we would rather say it here than have you find out after printing.

Prints in two pieces. A 254 x 89 mm panel is over the bed, so it splits down the middle and the halves lap. The seam runs between the two fans, never through a bore.

In the box: both halves, eight M4 x 30 self-tapping fan screws, and the two M3 x 12 screws and nyloc nuts for the seam.

You supply the fans. Bearing type, noise and airflow are yours to choose.

Choose: 60 or 80 mm, and the guard pattern.