PSU Tray, 3U

For our 10-inch rack. A 3U tray for a full-size ATX supply in our 10-inch rack. Its 86 mm inlet face needs 3U once the supporting floor is included.

Choose Left, Center or Right placement and either printed straps or the verified ATX inlet-face screw pattern. The screw-mounted version uses connected tabs around the face opening; the strapped version has two straps with accessible M4 screw seats.

Choose solid face, ventilation, fan mounts, keystone ports or cable openings independently on either side of the PSU. Choices follow the space left by the selected supply and attachment. Fan, jack and cable layouts require measured component, plug and lead-clearance dimensions; unavailable layouts cannot be ordered.

Each filled side adds one printed plate. You supply its four M3 x 16 screws, four M3 nuts and eight thin washers, plus any fans, compatible fan screws or keystone jacks. Fills support ATX, SFX, SFX-L and TFX; legacy Flex ATX and custom bodies retain a solid face.

Set the floor depth to suit your actual supply and lead routing. ATX specifies an inlet face and mounting pattern, while purchased case depths vary.

You supply the PSU and, for screw mounting, the compatible 6-32 screws. Choose position, retention, depth and floor venting.

Prints in six pieces at the default settings. Other layouts or retention choices can change the printed-piece and hardware counts; the parts list follows the selected configuration.